AL-KO HT 700 Instruction Manual download pdf (Page 17)

470519_b

HT 600, HT 700

Operation

Danger – risk of injury!

The machine must not be operated before as-

sembly work has been completed!

Observe the safety instructions for operation!

Adjust the front hand grip.1.

Pull out the quick-release levera.

Move the hand grip to the desired positionb.

Push the quick-release lever back inc.

Plug the power cable into the mains power

supply.

3. Grip the front hand grip with one hand, then grip

the rear hand grip with the other hand.

4. Press the switches on both hand grips (

4) –

the machine will start.

5. Keep both switches pressed while working.

6. The hedge trimmer will stop immediately if one

of the switches is released.

Work instructions

Always cut both sides of the hedge ﬁ rst, before 

cutting the top.

This will prevent cut material from falling into

areas that have not yet been cut.

The built-in spirit level facilitates cutting along



a straight line ( 5).

Hedges should always be cut in a trapezoid



shape. This prevents the lower branches from

becoming bare ( 8).

Repairs

Repair work may only be carried out by compe- 

tent specialist workshops or our AL-KO Service

Centres.

Safety instructions for operation

Always operate the machine with both 

hands.

Keep body and clothing away from cutting



parts.

Do not remove cut material while the mo- 

tor is running.

When leaving unattended / transporting



the machine:

Switch the machine off.



Pull out the mains plug. 

Push on the safety cover. 

Never hold the machine by the blade. 

Only carry the machine by the hand grip. 

The domestic mains voltage must match 

the mains voltage speciﬁ cations in the

technical data.

Always use the special cable strain relief



for the extension lead.

Always keep the cable out of the cutting 

area and routed away from the machine.

Assembly

The camera symbol refers to illustrations on

page 3.

Fasten the handguard to the housing using the 1.

screws provided (

1).

Pull the hand grip apart slightly and push it onto 2.

the housing (

2a). The toothing must click

into place.

Pull out the quick-release lever on the hand grip 3.

and hold it in place.(

2b)

Push the clamping bolt through the hand grip 4.

and housing and screw it into the quick-release

lever by hand. (

2c)

Screw the clamping bolt in so far that the quick-5.

release lever can be pushed against the hand

grip with little force.

Route the extension lead through the strain 6.

relief (

3).

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 229 230

Comments to this Manuals

No comments

AL-KO HT 700 Instruction Manual Page 17

Comments to this Manuals

Related products and manuals for Power hedge trimmers AL-KO HT 700